The reference belt for occasional use. It is recommended for treating recurrent conditions during daily activities which out pressure on the lower back.
Reinforced lumbar support belt. Available in height: 26cm and also available in three different sizes: 1, 2 , 3
Osteoarthritis patient with risk of low back pain, e.g.: active aged person
-High elastic compression and strength thanks to the Lombax® fabric
-Easy to put on thanks to the two part closure
-Increased comfort and breathability thanks to the 3D weave dorsal plastron
-Place your right hand into the lowest strap with the label "THUASNE". Place the brace around your back ( label which is most inside needs to be on top). Push the brace with your left hand flat against your abdomen without pulling onto it.
-Now pull the brace with your left hand (first straight ahead than more to the left side) to fasten the belt and place then the lowest strap onto the lowest part of the opposite side.
-Repeat the same procedure with the upper strap.
-Now check with your hands that center of the brace with the textile between the two middle stays (there are 4 stays in total) are placed onto the back of your vertebral column to optimize and/or adjust the centralisation of the brace.
-Please adjust the fitting of the brace to your optimal comfort, for example loosening when sitting.
Measure the waist at the level of the navel